|Hydraulic Conversion Kits for Ford N-series Tractors|
|HH-PMK-9||Basic pump mounting kit for all Ford N-series tractors equipped with a front distributor. Consists of timing belt drive, pump mounting brackets, and all hardware needed to install the kit on the tractor. Does not include a pump or any hydraulic components.||$250.00|
|HH-FPK-9N-AA||Basic fluid power kit for all Ford N-series tractors equipped with a front distributor. Contains all parts needed to equip the tractor with live hydraulics only. Consists of a basic pump mounting kit (HH-PMK-9N), a 3 GPM SAE-AA two bolt pump, and all hydraulic components needed to complete the conversion.||$425.00|
Deluxe fluid power kit for all Ford N-series tractors equipped with a front distributor. Contains basic parts needed to equip the tractor with high flow live hydraulics. . Consists of a basic pump mounting kit (HH-PMK-9N), your choice of a one of five different size SAE-A two bolt pumps, a priority flow divider, and all hydraulic components needed to plumb the pump to the tractors hydraulic system. Auxiliary control valves and remote ports are not included in the kit and must be configured separately. Auxiliary port connectors are JIC 8M (pressure) and SAE 12 ORB (tank return/relief).
Specify pump size desired by replacing the -xx in the order number with the appropriate pump dash size from the table below.
conversion kit for tractors already equipped with a front end
loader mounted shaft driven "stinger" pump. Modifies the
loader pump to use the internal sump on the tractor and splits
the pump output into a 3 GPM priority circuit for live
hydraulics (tractore test port) and an excess flow circuit for
the loader control valve. Return flow from the loader circuit
is routed to the tractor sump via the fill plug on the
WARNING: Designed for use with open center loader control valves with built in or external pressure relief only. See comments above
Does not include pressure or return hoses to loader control valve. Specify type and size of pressure and suction ports on loader pump when ordering
|Suction Line Strainer Kit|
|Suction line strainer (100 mesh, 5 PSI bypass) with engine block mounting bracket and all plumbing needed to connect to fluid power kits above||$30.00|
|Remote Quick Disconnects|
Two complete 1/2" NPT quick disconnect coupler assemblies, breakaway mounting bracket, and all plumbing needed to connect them to the remote ports of the deluxe fluid power kit above. Suitable for mounting on right rear fender or behind seat.
|Call for quote|